Knives/Knife Sets

Knives/Knife Sets

Typical Hobby Knife Handles

From Top to Bottom:

  • #6 Handle

    This is a heaviest duty hobby knife handle I've seen.  Next step up from this are utility and pocket knives.  This handle can mount the largest hobby blades as well as razor saws and gouges.

  • #5 Handle

    This handle can mount everything the #6 handle can.  The #5 is much lighter than the #6 and more comfortable for carving and sawing than the #2 handle.  The #2 handles is better for general cutting.

  • #2 Handle

    Like the #5 and #6 handles, the #2 handle can mount the largest hobby blades.

Note that the #2, #5 and #6 handle can mount all the same blades and saws.  Some #2 handles don't have a hole in the collet and can't mount razor saws or gouges.

  • #1 Handle

    The next three handles below the #2 are all #1 handles.  I don't have a "true" #1 handle any more because the first handle below the #2 is much more comfortable I own three of these handles.  Two of them have #11 blades and one of them has a #11 saw blade (discussed with blades in the previous section).  The third handle below the #2 has a chuck at both ends and was included in a chisel set.

  • Swivel Knife Handle

    Used for cutting around curved templates such as French curves.

  • Micro Chisel

    This handle is very small and best suited for fine detail work.

Items 13-20 of 20

Page
Show per page
Set Descending Direction

Items 13-20 of 20

Page
Show per page
Set Descending Direction
Please note that phone orders should only be called in from 9am to 5pm EST. You may leave a message with voicemail after hours or e-mail us. Thank You!